Formfutura - StoneFil Pottery clay - 500g
StoneFil est un filament à base de PLA qui est basé sur notre composé PLA EasyFil modifié et facile à imprimer et est rempli gravimétriquement avec 50% de pierre en poudre.
Ce «remplissage de pierre» élevé a abouti à un filament d'imprimante 3D avec des caractéristiques esthétiques remarquables et une densité de matériau nettement plus élevée jusqu'à 37% plus élevée que le PLA «normal». StoneFil est un filament d'imprimante 3D facile à imprimer et les objets imprimés ont une finition extrêmement mate en forme de pierre.
Formfutura - StoneFil Pottery clay - 500g
Unique features
-
Easy to print
-
50% gravimetric powdered stone filling
-
-
±37% heavier than “normal” PLA
-
-
Matte and rough stone-like finish
General printing guidelines *
| Nozzle size: ≥ 0.4mm | Layer height: ≥ 0.2mm | Flow rate: ± 110% |
| Print temp: ± 215 - 230° C | Print speed: High / Medium | Retraction: Yes ± 5mm |
| Heat bed: ± 0 - 60° C | Fan speed: 50-100% | Experience level: Beginner |
*) Above displayed settings are meant as guidance to find your optimal print settings. These ranges in settings should work for most printers, but please do feel free to experiment outside these ranges if you think it is suitable for your printer. There are a lot of different type of printers, hot-ends and printer offsets that it is extremely difficult to give an overall one-size-fits-all setting.
Abrasiveness
StoneFil has a very high filling with stone powders and therefore the filament can have a slightly more abrasive effect on brass nozzles than unfilled filaments.
Filament length
| ρ: 1.70 g/cc | 50 gr coil | 0.5 Kg spool | |||
| Ø 1.75mm | ± 12.2m | ± 122m | |||
| Ø 2.85mm | ± 4.6m | ± 46m |
Nozzle cleaning
When printing with filled/composite filaments it is recommended to clean your nozzle immediately after printing by feeding 15-20cm PLA filament through your nozzle. This will make sure that any potential fillers are flown out of your nozzle. It is even better to use glow in the dark PLA as the extremely hard phosphorous particles are much more likely to scrape out residual waste from your nozzle.
Product export information
| HS Code: 39169090 | Description: Monofilament | Country of origin: the Netherlands |
Compliance *
This filament is compliant to below listed directives and regulations.
-
RoHS directive 2011/65/EC
-
REACH directive 1907/2006/EC
*) This declaration of conformity to directives and regulations is prepared according to our present standard of knowledge and may be amended if new cognitions are available and applies only for the above described products.